Why do I hear water in my baseboard heating? - Liquid Image (2023)

If you are hearing water in your baseboard heating, it is likely that there is a problem with the water pressure in your radiator. This type of heating system is usually heated by a boiler that pumps hot water through the system at a certain pressure.

If the pressure is too high, air may be forced out of the system and cause a noise. Additionally, if the pipes in your system are loose or broken, air can enter the radiator, creating a similar sound.

If the water pressure is not the problem, then it is possible that the sound is caused by the potable water line in your home. If the water line is close to the baseboard heater and the pipes are not insulated properly, the water in the pipe could create a hissing or rattling sound when it flows past the baseboard heater.

You should have a professional inspect your system to diagnose the source of the sound and recommend a solution.

Table of Contents

How do I stop my baseboard heater from gurgling?

It is a common problem for baseboard heaters to make gurgling noises. Fortunately, it is usually not a sign of serious mechanical failure and can usually be resolved by cleaning and replacing components.

First, turn off the power to the heater before you start any maintenance. Then, locate the drain valve and open it to drain the water. Make sure to wait until all of the air has been fully expelled. Once you have drained the water, check the valve for any debris that may have collected there.

Remove any debris and clean around the valve thoroughly.

If the gurgling persists, you may need to replace the valve. Replacing the valve will require you to shut off the water supply to the heater, disconnect the water lines, and remove the old valve. Once the valve has been removed, replace it with a new one.

(Video) How to Quiet Noisy Baseboard Heat | Ask This Old House

Make sure to only use a valve that is compatible with your particular heater. To complete the installation, connect the water lines, turn on the power and water supply, and open the drain valve to fill the heater with water.

If the gurgling continues even after replacing the valve, it is possible that the gurgling sound is caused by a disruption in the flow of water in the system. To fix this issue, you can try using a proprietary fitting designed to reduce turbulence and increase the flow of the water.

These fittings can usually be found at your local hardware store. Follow the manufacturer’s instructions for the installation.

If the gurgling persists, you may want to contact a professional to inspect the system and determine what further action needs to be taken.

Why does it sound like water in my heater?

When it sounds like water in a water heater, it can be caused by several different things. One common issue is if you have a buildup of sediment in your water heater that can cause a loud, knocking sound when it is heated.

This is because the sediment can settle at the bottom of the water heater tank and cause the water to boil more quickly and make a loud noise. Another reason for a water heater sound could be that the heating elements have become worn out and need to be replaced.

An additional possible cause could be an issue with the heating controls. If the temperature is set too high, it can cause the water to boil too quickly and create a loud noise. It’s also possible that there could be air in the water that is creating a vibration when it is heated, resulting in a loud noise coming from the heater.

In any case, if you’re hearing a water heating sound coming from your heater, it’s important to contact a qualified technician to inspect the water heater and make the necessary repairs. This will ensure your water heater is functioning properly and the noise is eliminated.

Do baseboard heaters have water in them?

No, baseboard heaters do not have water in them. Baseboard heaters use electricity to warm up coils inside the unit, which then heats up a metal, aluminum, or copper tubing filled with a heat-transferring liquid, typically either water or glycol, and this liquid is then circulated throughout the unit.

The liquid heats up and radiates heat, rather than a traditional furnace that uses a system of vents and ducts to move heated air throughout a space. A baseboard heater transfers heat more directly and efficiently to the space, making it a popular choice for homes where space is tight and to reduce energy costs.

Can hear water rushing through radiators?

Yes, you can hear water rushing through radiators. This sound is caused by the expansion and contraction of the metal components in the radiator due to changes in temperature. As the water temperature inside the radiator rises, the steel components of the radiator expand, and as the water temperature cools, the steel components contract.

(Video) How To Bleed Trapped Air From Baseboard Heater

The resulting noises are typically a rapid gurgling or bubbling sound that can last up to several seconds, depending on how long it takes for the radiator to reach its desired temperature. In some cases, the sound can be relatively loud and distracting, which can be a nuisance in the home.

In this case, the best solution is to check the radiator to make sure it is functioning properly and to clean any blockages such as dust or debris from the system.

Can baseboard heat start a fire?

Yes, baseboard heat can start a fire if proper maintenance and safety precautions are not observed. As baseboard heating systems heat the air in a room, dust buildup, improper wiring, and direct contact of combustible materials with the heating element can cause a fire.

As such, baseboard heating systems should be inspected and maintained regularly and homeowners should be careful to keep all combustible materials away from the heating elements. Additionally, it is important to properly wire the unit per local building code and to not overload electrical outlets with too many appliances.

Homeowners should also look for any signs of an overheated system, including hot wall plates and yellow or orange flames coming from the heating element, and promptly shut off the system if any of these signs appear.

What liquid is in baseboard heaters?

Baseboard heaters are powered by a variety of liquid substances, depending on the heater. Some of the most common liquids used are water, steam, and various types of non-toxic antifreeze. Electric baseboard heaters usually contain a liquid usually composed of either a type of glycol antifreeze, a mix of water and ethylene glycol or a water-based solution.

Natural gas or propane baseboard heaters, on the other hand, generally contain a non-toxic coolant that is designed for the purpose, with less emphasis on the need for freezing protection. Whatever the liquid used, the heater must contain an antifreeze mixture to prevent corrosion and scale buildup in the heating elements when the liquid is heated above the boiling point.

The liquid within the heater also helps transfer the heat generated to the fins, so it is important to keep the liquid from becoming stagnant or clotting.

How do you add water to a baseboard heater?

Adding water to a baseboard heater is a relatively simple process. If you have an older model, you’ll need to open the access panel and manually add water. Make sure you’ve identified which valve is for cold water and which is for hot water.

Turn off the power to the unit before you begin. Typically, there are small valves located near the bottom of each pipe. For the cold water, you can use a garden hose, or an automotive siphon, to fill it up.

Make sure you do not overfill it. Once you’ve added the water, turn the power back on to the unit and check it to make sure the water is circulating correctly.

(Video) water leaking from baseboard when zone calles for heat

If you have a newer model, you may have the ability to open and close valves manually. If so, open the cold water valve and allow it to fill the pipes until you can see water seeping out of the heater’s access panel.

Quickly shut the valve, or you’ll risk overflowing the system with water. Once the unit is full, turn the power back on.

No matter which type of heater you have, it’s important to check the manufacturer’s instructions before adding water. This will help ensure the system is being filled properly and the amount of water that is being added is correct.

Can you get carbon monoxide poisoning from baseboard heaters?

Yes, carbon monoxide poisoning from baseboard heaters is a potential hazard. Carbon monoxide (CO) is an odorless and colorless gas that can be hazardous to humans in high concentrations. Baseboard heaters often use combustion fuel to create heat, so they can be a source of carbon monoxide gas.

If the baseboard heater is not properly maintained and vents are plugged or there is a crack in the heater, the carbon monoxide can quickly build up and become hazardous. If carbon monoxide levels become too high, it can make you feel dizzy, light-headed, nauseous, and experience headaches.

In severe cases, it can cause death. It is important to regularly maintain and check baseboard heaters to avoid carbon monoxide poisoning. This includes having a certified technician inspect the unit and its vents regularly, testing the unit for CO with a carbon monoxide detector, and ensuring that the area around the heater is well-ventilated.

How long do baseboard heaters last?

Baseboard heaters typically last anywhere between 10 and 20 years, depending on the model, brand, and quality of installation. High-quality units, properly maintained and serviced on a regular basis, may last up to 25 years; however, some systems may fail earlier than the average due to factors such as corrosion, vibration, and incorrect wiring.

Factors such as exposure to water, regular use, and quality of material used also affect the longevity of the unit. A well-maintained baseboard heater with regular cleaning and annual service can increase its lifespan and even prevent unexpected repairs or malfunctions.

Why are baseboard heaters under windows?

Baseboard heaters are often located under windows because of the cold air that can come in through the window itself. The baseboard heaters help to maximize the airflow coming in and ensure that the air around the window gets evenly heated.

This is especially important because cold air can settle around a window and cause an uncomfortable draft for anyone in the room. By having a baseboard heater directly under or next to the window, the warm air from the heater helps to counterbalance the cold air from outside, creating a more comfortable atmosphere.

Additionally, baseboard heaters can be used to provide supplemental heating for rooms with large windows or as the primary source of heat for a room without a central heating system.

(Video) How to Bleed Air From Baseboards - Hydronic/Base-Ray/Boiler/Burnham

Is it normal for baseboard heaters to make noise?

Yes, it is normal for baseboard heaters to make noise. This noise is usually caused by the expansion and contraction of the metal as the heater heats up and cools down. Depending on the size and age of the heater, the noise can range from a low hum to a loud rattling noise.

It is also normal for baseboard heaters to emit a slight odor due to the oil used to lubricate the fan motor and the dust that accumulates in the heater over time. Additionally, many baseboard heaters will make noises due to their use of a fan.

However, if the sound coming from the heater is out of the ordinary, it could be a sign of an issue and is worth investigating.

Can I put a couch in front of a baseboard heater?

In general, it is not safe to put a couch in front of a baseboard heater. Baseboard heaters get incredibly hot, and the fabric of couches can easily be damaged by the heat, leading to a fire hazard. Furthermore, heat radiating off of the baseboard heater could overheat the couch, leading to discoloration and wear-and-tear on the material.

If the couch is a good distance away from the heater, with several feet between them, then it may be safe to put it there. In order to further reduce the likelihood of a fire, make sure the couch isn’t blocking the flow of air from the baseboard heater, as this would cause it to overheat.

Additionally, if you have small children or pets at home, be mindful of their safety and keep the couch a safe distance away from the heater.

Why does my radiator sound like it’s filling with water?

Your radiator may sound like it is filling with water because it is. Radiators contain water, which is heated and then circulated through the radiator to heat your home. When the water is heated, it expands, causing the radiator to become hot and the water to be expelled out of the filling cap at the top.

This can create a sound similar to water filling the radiator. Additionally, radiators often have air pockets within them that need to be purged in order for the radiator to function properly. This can also cause a sound similar to water filling the radiator as the air is forced out.

How do I stop my radiator from making water noises?

The most common cause of water noises coming from a radiator is air in the system. To remedy this, you will need to vent the air from the radiator. Before you start, make sure that the boiler is off and has completely cooled down.

Then, begin to remove the vent valve on the radiator by turning it counterclockwise. Place a container or bowl underneath the vent valve while bleeding it; this will catch any excess water that may come out.

Be sure to use a key, flatblade screwdriver or a radiator key to turn the valve rather than using an adjustable wrench.

(Video) How to bleed baseboard heat 2 zone boiler

Once the majority of the air is out of the system, close the valve and take a look at the water level in the system’s header tank (it’s usually located in the loft). If it has dropped significantly, add more water to bring it back up to the correct level, ensuring that the system is pressurised correctly.

Once the air has been removed and the system is full of water, you can turn the boiler back on and test the radiators. If the noise is still there, it could be caused by something else that is more serious, such as a failing pump, leaking valves or damaged pipes.

If this is the case, then it might be best to speak to a qualified and experienced engineer.


1. Baseboard Radiators Not Heating Room Up
(A Concord Carpenter / ToolBoxBuzz)
2. Hear Water Dripping, but Can’t Find Any Water Damage?
(BJ Poznecki)
3. Installing Hot Water Baseboards
(The HVAC Hacker)
4. How to Move Baseboard Heating | Ask This Old House
(This Old House)
(Mowers N Blowers)
6. Upgrade Your Baseboard Heaters with Neatheat Baseboard Heater Covers
(Homeowner Helper)


Top Articles
Latest Posts
Article information

Author: Terence Hammes MD

Last Updated: 02/05/2023

Views: 5563

Rating: 4.9 / 5 (49 voted)

Reviews: 88% of readers found this page helpful

Author information

Name: Terence Hammes MD

Birthday: 1992-04-11

Address: Suite 408 9446 Mercy Mews, West Roxie, CT 04904

Phone: +50312511349175

Job: Product Consulting Liaison

Hobby: Jogging, Motor sports, Nordic skating, Jigsaw puzzles, Bird watching, Nordic skating, Sculpting

Introduction: My name is Terence Hammes MD, I am a inexpensive, energetic, jolly, faithful, cheerful, proud, rich person who loves writing and wants to share my knowledge and understanding with you.